Why does my existing serial cable not work with the updated SpeedCheck controller?

This article details the two serial cable versions and which SpeedCheck controllers are supported.

Product applicability

The following products are discussed in this article:

  • SpeedCheck: SPEEDCHECK-15 and SPEEDCHECK-18 

With Applied Information option.

With the release of an updated controller in 2021 Q4 for the SPEEDCHECK-15 and SPEEDCHECK-18 radar speed signs we have also released an updated version of the serial cable used for remote connectivity with Applied Information. If you have received a new controller and have an existing configuration that utilizes the 10-pin serial cable you may need to replace the cable for the updated version.

Updated Serial Cable Legacy Serial Cable

4-wire version, supported by the updated and legacy controllers. Legacy controller requires the locking levers removed.  3-wire version, only supported by the legacy control board.

For more information on the updated SpeedCheck controller please see our article here.

Controller Version Cable Orientation Supported Serial Cable

Updated


Updated

Legacy

(phased out 2022 Q4)

Legacy or Updated
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.