How do I install and remove batteries in the MX SpeedCheck Module cabinet?

This article details installing and removing batteries in the MX SpeedCheck Module cabinet .

Product applicability

The following products are discussed in this article:

  • MX Series: SPEEDCHECK-MX

MX SpeedCheck Module cabinets house up to two 18 Ah batteries.

Installation

  1. Unlock and open cabinet.
  2. Install battery(s) as shown above.
    1. Push battery(s) fully toward rear of cabinet.
    2. Ensure battery retainer fully engages and secures battery(s).
  3. Connect battery harness(es) to retainer bracket.

Removal

  1. Unlock and open cabinet.
  2. Disconnect battery harness(es) from retainer bracket.
  3. Push in on retainer bracket and remove battery(s).

Ensure battery boots cover entire battery terminals.

Ensure battery terminals face forward towards system display.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.