How do I perform a hard reset on my SPEEDCHECK-15/18 controller?

This article details the procedure for performing a hard reset on the controller within your SPEEDCHECK-15/18 radar speed sign.

Product applicability

The following products are discussed in this article:

SpeedCheck: SPEEDCHECK-15 and SPEEDCHECK-18

Scenarios requiring a hard reset

If you encounter one of the following scenarios it may be necessary to perform a hard reset:

Display LED's are stuck on "88" or "SLOW DOWN"
Cannot connect to controller via Bluetooth with SpeedCheck Manager (programmable boards only)
Radar not detecting traffic

In all of these instances you will want to ensure your input power (battery or AC/DC power supply) going into the control board is serviceable (12VDC nominal).

Controller Type	Hard Reset Procedure
Legacy Classic Controller	Remove input power and reapply
Legacy Programmable Controller (phased out October 2022)	Momentarily short two pins together with power applied¹
Updated Programmable Controller (new release ~2021 Q4)	Remove input power and reapply

Controller Type

Hard Reset Procedure

Legacy Classic Controller

Remove input power and reapply

Legacy Programmable Controller

(phased out October 2022)

Momentarily short two pins together with power applied¹

Updated Programmable Controller

(new release ~2021 Q4)

Remove input power and reapply

¹ Ensure the coin cells (CR2032) are installed and measuring at least 2.7V each. If not, replace them. If coin cells are not installed then the blue jumper in the upper right hand corner of the board near the LED wiring must be installed for controller to power up.

Procedure

Classic Controller	Open the fuse holder to remove power to the system. Wait a few seconds and then close the fuse holder to reapply power. Wait 45 seconds for the system to boot up and complete its test sequence. Confirm system is now detecting vehicles and operating properly.
Legacy Programmable Controller	Locate the reset pins indicated in red in the image below on the control board. Short the two pins together momentarily with small flat head screwdriver while power is applied to the system. Wait 45 seconds for the system boot up and complete its test sequence. Confirm system is now detecting vehicles and operating properly.
Updated Programmable Controller	Open the fuse holder to remove power to the system. Wait a few seconds and then close the fuse holder to reapply power. Wait 15 seconds for the system to boot up and complete its test sequence. Confirm system is now detecting vehicles and operating properly.

Classic Controller

Open the fuse holder to remove power to the system. Wait a few seconds and then close the fuse holder to reapply power.
Wait 45 seconds for the system to boot up and complete its test sequence.
Confirm system is now detecting vehicles and operating properly.

Legacy Programmable Controller

Locate the reset pins indicated in red in the image below on the control board. Short the two pins together momentarily with small flat head screwdriver while power is applied to the system.
Wait 45 seconds for the system boot up and complete its test sequence.
Confirm system is now detecting vehicles and operating properly.

Updated Programmable Controller

Open the fuse holder to remove power to the system. Wait a few seconds and then close the fuse holder to reapply power.
Wait 15 seconds for the system to boot up and complete its test sequence.
Confirm system is now detecting vehicles and operating properly.

If you are still having issues with your system after performing a hard reset, please click on the chat icon on the bottom right and contact us.