How can I connect a third-party trigger to my Carmanah beacon system?
This article details integrating a third-party trigger to activate your Carmanah beacon system.
Product applicability
The following products are discussed in this article:
- E Series: R829-E and R247-E
- F Series: R829-F and R247-F
G Series: R829-G and R247-G
Carmanah beacon systems can accept a dry contact from a third-party system or device for activation purposes. This dry contact must be able to accept 12-15 VDC, which will be present at the connection terminals. A third-party output can be a from a variety of things such as signalized intersections, sensors, or detectors.
For instances that a dry contact output is not available you will need to use an isolation relay. Carmanah can provide this relay but you can integrate your own that is appropriately specified:
- DC to DC:
- Input = 4 VDC to 32 VDC
- Load = 5 VDC to 200 VDC
Output from an AC powered trigger will need an AC input/DC output relay.
See the information below on wiring and integrating a third-party trigger:
E/F Series |
|---|
|
G Series |
|---|
|
| Model | Relay Mounting Location | Wire Termination |
| E Series |
|
Energy Management System PCBA
|
| F Series |
|
Energy Management System PCBA:
|
| G Series |
|
G Series Input/Output Terminal block
|
Wire termination for the trigger is not polarity sensitive.
If you have any questions on your third-party trigger application, Contact Carmanah.