How do I wire the Polara iNX/iDX into my E/F/G Series system?
This article details the wiring for the Polara iNX/iDX push button into a compatible Carmanah system.
Product applicability
The following products are discussed in this article:
- E Series: R920-E and R820-E
- F Series: R920-F and R820-F
- G Series: SC315-G and R820-G
Please see the image below for wiring in the Polara iNX or iDX push button:
E/F Series | G Series |
---|---|
E/F Series systems are prewired by Carmanah and only require termination to the button. If you are retrofitting the Polara iNX/iDX button into an existing compatible system please see our guide here.
The G Series has exposed terminal blocks where Carmanah may or may not provide the push button wire harness.
For retrofitting opportunities please see our article here.
PWR/GND terminals at the iNX/iDX button will be filled with dielectric grease. Terminate wires with grease installed to prevent corrosion.